Re: Post procesor for Mach1

Try putting a Feed command as the first entry in the g-code file as
part of your header, and before any g1 commands. I found that fixed
the problem for me. This may have been fixed in Mach2 which is
pretty stable now and looking VERY good, but I can't recall if I've
retried that particular test without the added F50 command.

Can't help with the Alphacam post, but a generic model is usually
acceptable to Mach1/2.

Colin

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "ralaco" <ralaco@y...> wrote:
> Which Post processor do I need to choose in AlphaCAM to run Mach1.
>
> I have tried Alfa Standard and fanuc 6mb no rems
>
> I always get the path in the path tab, but Mach1 don't run.
>
> I'm getting some of these warnings:
> Error in File at Sequence Number : 11
> File LineNumber : 70
> Cannot do g1 with zero feed rate
> N70 G1 X1.253 B0. F0
>
> But I'm setting the cutting speed.
>
> Regards
> Raul Lara