Re: [CAD_CAM_EDM_DRO] Post procesor for Mach1

Raul,

I will send you one in the morning that should work. I am an AlphaCam dealer
and I think that the one that I have been using with another controller will
work. I am just setting up Mach1 here in my shop.

Bob Campbell

----- Original Message -----
From: "ralaco" <ralaco@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, May 08, 2003 1:42 PM
Subject: [CAD_CAM_EDM_DRO] Post procesor for Mach1


> Which Post processor do I need to choose in AlphaCAM to run Mach1.
>
> I have tried Alfa Standard and fanuc 6mb no rems
>
> I always get the path in the path tab, but Mach1 don't run.
>
> I'm getting some of these warnings:
> Error in File at Sequence Number : 11
> File LineNumber : 70
> Cannot do g1 with zero feed rate
> N70 G1 X1.253 B0. F0
>
> But I'm setting the cutting speed.
>
> Regards
> Raul Lara
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
> Moderator: pentam@... indigo_red@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>