small treasures, relays and stuff
Posted by
turbulatordude
on 2003-05-10 08:57:52 UTC
Hi all,
I happened past an alarm company, really small outfit, on trash night.
they were tossing a dozen or so old panels. I grabbed a bunch for
the enclosures, some had windows...
but then when I looked at the board, I realized that with a blowtorch
and some time, I could salvage a lot of parts. Probably could have
been done in an oven, but I am not sure if the flames would be worse
than heating the whole part. Probably could have just turned it
upside down over some aluminum foil until parts dropped ?
I just heated the solder till fluid, then tapped the board on ground
and all kinds of stuff fell out. One board had all the pins bent so
I didn't even bother with that one. :(
now,I have bunches of terminal connections and bunches of relays and
even a 10kuF/50V cap !
and a couple medium amp (5-10amp) transformers @ 24 volts.
Wonderful source for parts and all free.
I bet that some of the boards could have been used as-is for relays
and led's and stuff.
Dave
I happened past an alarm company, really small outfit, on trash night.
they were tossing a dozen or so old panels. I grabbed a bunch for
the enclosures, some had windows...
but then when I looked at the board, I realized that with a blowtorch
and some time, I could salvage a lot of parts. Probably could have
been done in an oven, but I am not sure if the flames would be worse
than heating the whole part. Probably could have just turned it
upside down over some aluminum foil until parts dropped ?
I just heated the solder till fluid, then tapped the board on ground
and all kinds of stuff fell out. One board had all the pins bent so
I didn't even bother with that one. :(
now,I have bunches of terminal connections and bunches of relays and
even a 10kuF/50V cap !
and a couple medium amp (5-10amp) transformers @ 24 volts.
Wonderful source for parts and all free.
I bet that some of the boards could have been used as-is for relays
and led's and stuff.
Dave
Discussion Thread
turbulatordude
2003-05-10 08:57:52 UTC
small treasures, relays and stuff
JanRwl@A...
2003-05-11 13:19:42 UTC
Re: [CAD_CAM_EDM_DRO] small treasures, relays and stuff