Re: Beginner question regarding Controller.
Posted by
jeffalanp
on 2003-05-22 08:19:47 UTC
Hi Frank,
If you are also looking for a stepper motor driver to go along
with your stepper motors to complete your CNC system, take a look at
my web site. I sell a 3 axis bipolar 'chopper' type drive that will
handle up to 2.5A/phase, with a max running voltage of 30V (35V peak,
but a typical running voltage is 24 though).
http://www.xylotex.com
Jeff
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Frank Frank <ffrank@s...>
wrote:
If you are also looking for a stepper motor driver to go along
with your stepper motors to complete your CNC system, take a look at
my web site. I sell a 3 axis bipolar 'chopper' type drive that will
handle up to 2.5A/phase, with a max running voltage of 30V (35V peak,
but a typical running voltage is 24 though).
http://www.xylotex.com
Jeff
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Frank Frank <ffrank@s...>
wrote:
> Folks,Sherline
>
> I hope I am not off topic here, but I am trying to take a small
> mill, and add CNC capability to it. I have some small Bipolarsteppers
> already mounted, and am now trying to determine a reasonable hobbycontroller.
>create the
> I am working with 3 axis right now, and have used Solidworks to
> parts I would like to mill.good used one?
>
> Can anyone recommend a cost effective controller, perhaps even a
>
>
>
> Frank Frank CID+
> Accelerated Designs, Inc
> 128 Daniel Dr.
> Huntsville, Alabama 35811
> (256) 858-8568 Voice
> (256) 851-8156 Fax
> ffrank@A...
> ICQ:29838854
>
>
> http://www.Accelerated-Designs.com
Discussion Thread
forumtvm
2003-05-21 14:12:34 UTC
new list for flashcutcnc users, fans
Frank Frank
2003-05-22 00:18:54 UTC
Beginner question regarding Controller.
forumtvm
2003-05-22 07:45:44 UTC
Re: Beginner question regarding Controller.
forumtvm
2003-05-22 07:52:27 UTC
Re: Beginner question regarding Controller.
jeffalanp
2003-05-22 08:19:47 UTC
Re: Beginner question regarding Controller.
Jon Elson
2003-05-22 08:30:54 UTC
Re: [CAD_CAM_EDM_DRO] Beginner question regarding Controller.
Ross
2003-05-22 08:41:08 UTC
Re: Beginner question regarding Controller.
Jim Wilson
2003-05-22 09:09:43 UTC
Re: [CAD_CAM_EDM_DRO] Beginner question regarding Controller.
JanRwl@A...
2003-05-22 10:05:28 UTC
Re: [CAD_CAM_EDM_DRO] Beginner question regarding Controller.
Fred Smith
2003-05-22 10:43:28 UTC
Re: Beginner question regarding Controller.
Alan Marconett KM6VV
2003-05-22 10:44:26 UTC
Re: [CAD_CAM_EDM_DRO] Beginner question regarding Controller.