Re: Galil - CNC Software
Posted by
motovidia
on 2003-05-26 10:23:10 UTC
Bazer,
I use the Galil/JRA Co combo.(using brush servo's)
Initially I had my doubts. Without a doubt it works as advertised.
It very easy & simple to setup & use. I had zero problems during
setup.
Jay Joyner (owner of JRA) provides excellent support & is constantly
adding new features to WingCNC, you can call him (248-336-9439) or
email him (jjoyner101@...)
I have some pics & specs at
http://www.motovidia.com/MILL%20pics
Femi
I use the Galil/JRA Co combo.(using brush servo's)
Initially I had my doubts. Without a doubt it works as advertised.
It very easy & simple to setup & use. I had zero problems during
setup.
Jay Joyner (owner of JRA) provides excellent support & is constantly
adding new features to WingCNC, you can call him (248-336-9439) or
email him (jjoyner101@...)
I have some pics & specs at
http://www.motovidia.com/MILL%20pics
Femi
Discussion Thread
bazer_20002000
2003-05-26 09:29:26 UTC
Galil - CNC Software
motovidia
2003-05-26 10:22:43 UTC
Re: Galil - CNC Software
motovidia
2003-05-26 10:23:10 UTC
Re: Galil - CNC Software