RE: [CAD_CAM_EDM_DRO] Re: Servo Drive - step multiplier

Mariss,

It may be your least favorite reason and I am sure you are correct about
it technically, but I can assure you it is probably a major selling
factor.

Tim
[Denver, CO]
Sherline products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline

> -----Original Message-----
> Tim,
>
> Didn't think of that one, probably because it's my least favorite.
> All parallel ports can sink 16mA or more, not all can source 16mA. If
> it can't, then you get increased noise suceptability and possible
> miss-positioning of whatever you are running with it.
>
> Unless you have an oscilliscope you can't tell easily if your
> particular port can or can't.
>
> Mariss