CAD CAM EDM DRO - Yahoo Group Archive

RE: [CAD_CAM_EDM_DRO] AMAZING STUFF!

on 2000-03-13 08:22:21 UTC
> -----Original Message-----
> From: Tim Goldstein [SMTP:timg@...]
> Sent: Saturday, March 11, 2000 2:02 PM
> To: CAD_CAM_EDM_DRO@onelist.com
> Subject: RE: [CAD_CAM_EDM_DRO] AMAZING STUFF!
>
> From: "Tim Goldstein" <timg@...>
>
> Finally, if you check
> out
> http://www.microkinetics.com/motionc.htm
> And look at the OptiTracker card you will see "The OptiTracker can be used
> with MillMaster Pro for encoder feedback."
>
> Tim
> [Denver, CO]
>
I purchased the Optistep controller under the impression that in
conjunction with the Optitracker card one could obtain closed loop stepper
control. The documentation that came with Millmaster was vague on this so I
called Microkinetics for clarification. Turns out that Millmaster simply
executes a block of code, reads the encoders after the move and then adds or
subtracts additional steps (a separate commanded move) to get to the target
position. This is ok for making up one or two occasional lost steps but
won't help much if one axis gets significantly delinquent.

Doug Harrison

Discussion Thread

Dan Mauch 2000-03-10 06:52:51 UTC Re: [CAD_CAM_EDM_DRO] AMAZING STUFF! james owens 2000-03-11 10:31:02 UTC Re: [CAD_CAM_EDM_DRO] AMAZING STUFF! Ward M. 2000-03-11 11:02:43 UTC Re: [CAD_CAM_EDM_DRO] AMAZING STUFF! Tim Goldstein 2000-03-11 11:09:49 UTC RE: [CAD_CAM_EDM_DRO] AMAZING STUFF! Matt Shaver 2000-03-11 16:21:05 UTC Re: [CAD_CAM_EDM_DRO] AMAZING STUFF! Harrison, Doug 2000-03-13 08:22:21 UTC RE: [CAD_CAM_EDM_DRO] AMAZING STUFF! Terry May 2000-03-14 14:38:09 UTC Re: [CAD_CAM_EDM_DRO] AMAZING STUFF! Dan Mauch 2000-03-15 06:26:22 UTC Re: [CAD_CAM_EDM_DRO] AMAZING STUFF! Tim Goldstein 2000-04-08 19:36:08 UTC RE: [CAD_CAM_EDM_DRO] Camtronics offerings, was:AMAZING STUFF! Greg Nuspel 2000-04-09 08:31:25 UTC Re: [CAD_CAM_EDM_DRO] Camtronics offerings, was:AMAZING STUFF! Jerome Kimberlin 2000-04-09 17:18:49 UTC Re: [CAD_CAM_EDM_DRO] Camtronics offerings, was:AMAZING STUFF!