RE: [CAD_CAM_EDM_DRO] Photo to g-code for carving wood

I am a dealer so I am likely biased, but the image to g-code in DeskCNC
does a very good job and give you the choice of outline cutting or
height map. You can download a 30 day full featured demo at
www.DeskCNC.com While I have them available I am also offering the
controller board free with a DeskCNC license purchased through me. Offer
ends when I run out.

Tim
[Denver, CO]
Sherline products at Deep Discount
Mach1 & DeskCNC with credit card ordering
www.KTMarketing.com/Sherline

> -----Original Message-----
> I have been experimenting with several photo to g-code programs:
> bmptocnc, imagetogcode, etc. and have not come up with the product
> that I want. What I would like to do is convert a photo (deer,
> person, fish, etc.) and mill it into a piece of wood (award,
> gunstock, etc.) and have it look pretty close to the picture. The
> web site at imagetogcode.com show some very nice carvings that I want
> my photos to look like. Maybe I do not have my setting or cutting
> bit correct. Could someone give me some pointers, software ideas,
> and post some photo carving they have done?
>
> thanks
>
> Scott Hamilton
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html