Router table test
Posted by
res0clvs
on 2003-06-17 11:34:05 UTC
My 3 axis gantry router table is almost complete. Home and limit switches are not installed. All three servo motors tested with an SCR speed control.
Power supply, Gecko 320s, and breakout are wired, ready to be plugged in.
I intend place each axis at mid travel, connect each motor one at a time starting with X, and have TurboCNC move it 4 or 5 inches... Someone please tell me exactly how to accomplish this test?
Robert Williams
rob.will@...
[Non-text portions of this message have been removed]
Power supply, Gecko 320s, and breakout are wired, ready to be plugged in.
I intend place each axis at mid travel, connect each motor one at a time starting with X, and have TurboCNC move it 4 or 5 inches... Someone please tell me exactly how to accomplish this test?
Robert Williams
rob.will@...
[Non-text portions of this message have been removed]