RE: [CAD_CAM_EDM_DRO] Help with servo amps.
Posted by
Quale, Robert
on 2003-06-17 17:59:26 UTC
I got my boss apart. The servo amps are on boards num 1937997 and all
connected together on a mother board. Then the last slot has a board in
it that must give voltage info to the amp. All the boards say Bridgeport on
them.
How can I figure where the proper wires are? It's all slot stuff. I'm not
sure how to break in with wire connections Or should I sell the amps and use
a Rutex that requires a power supply only? This will also save space maybe
eliminating one whole cabinet. Also how do I figure encoder wires and tack
wires and is there a special combo pare thing going on?
The Rutex seems to be a better option to clean things up, I think? Or
should I use the amps at any expense and expect better performance?
Thanks for all the help.
Bob
connected together on a mother board. Then the last slot has a board in
it that must give voltage info to the amp. All the boards say Bridgeport on
them.
How can I figure where the proper wires are? It's all slot stuff. I'm not
sure how to break in with wire connections Or should I sell the amps and use
a Rutex that requires a power supply only? This will also save space maybe
eliminating one whole cabinet. Also how do I figure encoder wires and tack
wires and is there a special combo pare thing going on?
The Rutex seems to be a better option to clean things up, I think? Or
should I use the amps at any expense and expect better performance?
Thanks for all the help.
Bob
Discussion Thread
Quale, Robert
2003-06-17 17:59:26 UTC
RE: [CAD_CAM_EDM_DRO] Help with servo amps.
Jon Elson
2003-06-17 22:21:47 UTC
Re: [CAD_CAM_EDM_DRO] Help with servo amps.
Matt Shaver
2003-06-17 23:12:57 UTC
Re: [CAD_CAM_EDM_DRO] Help with servo amps.