TurboCadCam drawing prob
Posted by
mckenziecg
on 2003-06-23 13:53:40 UTC
I do not know if this is off subject are not i am sure someone will
let me know. I am using turbocadcam to do 2.5 inlay cutting in
wood. I like the cam section but the cad does not work well with
me. I am using another drawing program and saving the file in .dxf
format. TCC opens the file with out any problems but i cannot get it
to draw a toolpath for the drawing. I am very green at this stuff so
just bear with me. I was wondering if anyone had any suggestions.
Thanks for all the help Chris Mckenzie
let me know. I am using turbocadcam to do 2.5 inlay cutting in
wood. I like the cam section but the cad does not work well with
me. I am using another drawing program and saving the file in .dxf
format. TCC opens the file with out any problems but i cannot get it
to draw a toolpath for the drawing. I am very green at this stuff so
just bear with me. I was wondering if anyone had any suggestions.
Thanks for all the help Chris Mckenzie
Discussion Thread
mckenziecg
2003-06-23 13:53:40 UTC
TurboCadCam drawing prob
Greg Jackson
2003-06-23 20:27:27 UTC
RE: [CAD_CAM_EDM_DRO] TurboCadCam drawing prob
John Branlund
2003-06-24 06:44:01 UTC
Re: [CAD_CAM_EDM_DRO] TurboCadCam drawing prob
Christopher Mckenzie
2003-06-24 22:45:34 UTC
RE: [CAD_CAM_EDM_DRO] TurboCadCam drawing prob