rotary table drive
Posted by
Thomas Powell
on 2003-06-30 09:50:35 UTC
I set up a frog drive for my rotary table. The problem is that I can not
get a full revolution with the number of counts the driver has. Is there a
way to hook up the stepper so that it will just spin till I tell it to stop
with some kind of variable rate? Then switch back to the frog driver when I
need a certain number of step travel.
Thanks
====================================
Thomas Powell (VMOA 741)
1994 NOS injected T-Boost sales
Tourmaster V-Max Clear clutch cover sales
"LAFGAS"
tppjr@...
http://imageevent.com/tppjr (photopage)
====================================
get a full revolution with the number of counts the driver has. Is there a
way to hook up the stepper so that it will just spin till I tell it to stop
with some kind of variable rate? Then switch back to the frog driver when I
need a certain number of step travel.
Thanks
====================================
Thomas Powell (VMOA 741)
1994 NOS injected T-Boost sales
Tourmaster V-Max Clear clutch cover sales
"LAFGAS"
tppjr@...
http://imageevent.com/tppjr (photopage)
====================================
Discussion Thread
Thomas Powell
2003-06-30 09:50:35 UTC
rotary table drive
turbulatordude
2003-06-30 12:14:06 UTC
Re: rotary table drive