RE: [CAD_CAM_EDM_DRO] Servo Drive Question..Help!
Posted by
Quale, Robert
on 2003-07-10 04:27:41 UTC
Ron,
I have a similar setup I am working on now. I went with the Rutex drives.
They are put together well and compact. They have a mother board
arrangement that stream lines the setup. I don't have it all set up yet,
but so far so good. The Rite are 200V 40Amp. Let me know How you make out.
Through this board or off line.
Thanks Bob
I have a similar setup I am working on now. I went with the Rutex drives.
They are put together well and compact. They have a mother board
arrangement that stream lines the setup. I don't have it all set up yet,
but so far so good. The Rite are 200V 40Amp. Let me know How you make out.
Through this board or off line.
Thanks Bob
Discussion Thread
cnc6805
2003-07-09 17:04:11 UTC
Servo Drive Question..Help!
Tim Goldstein
2003-07-09 22:34:17 UTC
RE: [CAD_CAM_EDM_DRO] Servo Drive Question..Help!
Quale, Robert
2003-07-10 04:27:41 UTC
RE: [CAD_CAM_EDM_DRO] Servo Drive Question..Help!
Doug Fortune
2003-07-11 18:14:53 UTC
Re: [CAD_CAM_EDM_DRO] Servo Drive Question..Help!