RE: [CAD_CAM_EDM_DRO] help!!!

> -----Original Message-----
> Goodday everyone,
>
> If one cannot ask for help on whether to use locktite on nuts/screws
> for a motor driver box to secure DB25 terminals for a home-brewed CNC
> machine, where can one ask?
>
> Thanks
>
> A1

For those wondering about on and off topic, here is the official line on
how we determine when a post is on or off topic:

Here is our philosophy on determining on and off topic subjects.
We have to make a division somewhere or almost anything can be construed
as being a CNC topic. The general decision is that if the item would
have no meaning if you removed the CNC part it is on topic. On the other
hand if the answer is identical without the CNC in the question it is
not an appropriate topic. As an example if you ask "how do I machine
Delrin on my CNC machine?" it is off topic as it is really a general
shop question. Machining Delrin on a CNC machine is no different than
machining it on a manual machine. If the question is "Will Delrin work
as a good split nut on my home designed CNC router ?" that would be on
topic as it is specific to CNC as the wear and acceptable backlash are
different than on a manual machine.

In the case of using loctite on small screw the answer is the same if
the screw is in your CNC setup or your motorcycle.

If you want to read the full list rules they are mailed to the group
monthly or you can get to them from a link on the front page to this
group. You can hook to the directly at
http://www.timgoldstein.com/CAD_CAM/CCEDListRules.htm

Tim
[Denver, CO]