CAD CAM EDM DRO - Yahoo Group Archive

Re: Vinyl Cutting Algorithms

Posted by rainnea
on 2003-07-17 02:26:26 UTC
Forgot to add,
I put some pictures of the vinyl-cutter holding attatchment I made
for my router in the photos section of the CNC Toolkit forum;
http://photos.groups.yahoo.com/group/CNC_Toolkit/lst

Regards,
Rab


--- In CAD_CAM_EDM_DRO@yahoogroups.com, "fortino" <fortino_tan@h...>
wrote:
> Rab,
> Typically, the blade is not centered. It is offset about 0.1-0.2 mm
from the
> center.
> This offset would allow the knife to swivel/ turn every time it
changes
> direction.
> Beside, how about your knife? do you buy it or make it by yourself?
>
> I have two vinyl cutting machine that was driven by Gecko. The
mechanical
> part
> was build using chinese brand vinyl cutting machine. It uses
stepper motor.
>
> fortino
>

Discussion Thread

rainnea 2003-07-16 17:30:43 UTC Vinyl Cutting Algorithms fortino 2003-07-16 17:51:25 UTC Re: [CAD_CAM_EDM_DRO] Vinyl Cutting Algorithms rainnea 2003-07-17 02:12:26 UTC Re: Vinyl Cutting Algorithms rainnea 2003-07-17 02:26:26 UTC Re: Vinyl Cutting Algorithms alex likhterman 2003-07-17 10:19:40 UTC Re: [CAD_CAM_EDM_DRO] Re: Vinyl Cutting Algorithms fortino 2003-07-17 18:09:39 UTC Re: [CAD_CAM_EDM_DRO] Re: Vinyl Cutting Algorithms alex likhterman 2003-07-18 07:46:02 UTC Re: [CAD_CAM_EDM_DRO] Re: Vinyl Cutting Algorithms ballendo 2003-07-21 02:42:07 UTC Re: Vinyl Cutting Algorithms rainnea 2003-07-21 14:33:28 UTC Re: Vinyl Cutting Algorithms