Re: [CAD_CAM_EDM_DRO] CAM generating short lines not G02/G03 curvesegments
Posted by
Doug Fortune
on 2003-07-24 19:24:52 UTC
Alan Marconett KM6VV wrote:
then redrawing it in CAM). What happens when the original CAD gets
changed? ... you'd have to re-do all the CAM work again.
For one project that might be ok, but for a long term strategy it
looks like a time sinkhole.
But I'll look at it...
Doug Fortune
http://www.cncKITS.com
.
>That might work, but that doubles the time! (ie drawing it in CAD
> Hi Doug,
>
> After you've imported the DXF, can't you just redraw the arcs?
then redrawing it in CAM). What happens when the original CAD gets
changed? ... you'd have to re-do all the CAM work again.
For one project that might be ok, but for a long term strategy it
looks like a time sinkhole.
But I'll look at it...
Doug Fortune
http://www.cncKITS.com
.
Discussion Thread
Doug Fortune
2003-07-24 19:24:52 UTC
Re: [CAD_CAM_EDM_DRO] CAM generating short lines not G02/G03 curvesegments
Doug Fortune
2003-07-24 21:20:07 UTC
Re: [CAD_CAM_EDM_DRO] Re: CAM generating short lines not G02/G03 curvesegments