Re: DIY Three Axis DRO Kit

Scott, this is too much of a tease!

Can you give us more of an idea of what is involved?
Programmed processor?
Code available?
When can we get the beast?
Are you going to put more info on your site?

Sounds like you have put some effort into this!

I would love a board and parts list, I can fling hot solder with the
best of them and don't have the time to hack one of these scales.

I just put the second scale on my Midas with the third in the box,
and would love to be able to see the readouts in one place.

Great job.
Mark



--- In CAD_CAM_EDM_DRO@yahoogroups.com, "sshumate" <sshumate@y...>
wrote:

> I have finally finished my DIY three axis DRO. I set out to make a
> DRO as capable as the commercial versions but use the cheap Chinese
> digital scales and be low cost in its own right. The cost of the
> DRO parts minus the scale cables and PCB should be around $60-$70.
> I designed it to use common parts available at Digikey, Mouser, or
> the like and be all DIP devices to make it easier for someone to
> assemble it as a kit.
>