Re: Brifgeport Series II help

I think that would help. As far as the controler goes it had been
schavanged before I bought the machine. I just figure that with the
schematics I can make much easier work of finding everything I need
to hook up to - like the coolant systems for example - and not run
the risk of jacking up good parts. Do your schematics have the back
panel where the motors and various on machine systems hook up?

Doug

--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Tim" <luvindaddy@y...> wrote:
> Hello Doug,
> I have the complete schematics for the Boss3 & Boss5 controls?
> Would this help at all????
> I want to retrofit the Boss5 later this year & would like to learn
> from your experiences????
> Thanks,
> Tim Bostic
>
> --- In CAD_CAM_EDM_DRO@yahoogroups.com, "dougfennell2000"
> <dfennell@m...> wrote:
> > To Tim and everyone with a series II - does anyone have a
schematic
> > diag of the rear panel enclosure? Also, when looking at the
> terminal
> > block I see the motor outputs (X1 X2 X3 X4 X5 & X5 again) same
for
> Y
> > and Z - does anyone that has done a retrofit know the motor coil
> > pinouts?
> >
> > For all that are interested I plan to completly document this
> > retrofit and post it here for all to use. My current plan is to
> reuse
> > the steppers and the coolant systems and then retrofit servos at
a
> > later time. I think my API CMD-260's will run the current
steppers
> > without a problem.
> >
> > Thanx,
> > Doug