Brifgeport Series II help
Posted by
dougfennell2000
on 2003-08-06 14:15:07 UTC
To Tim and everyone with a series II - does anyone have a schematic
diag of the rear panel enclosure? Also, when looking at the terminal
block I see the motor outputs (X1 X2 X3 X4 X5 & X5 again) same for Y
and Z - does anyone that has done a retrofit know the motor coil
pinouts?
For all that are interested I plan to completly document this
retrofit and post it here for all to use. My current plan is to reuse
the steppers and the coolant systems and then retrofit servos at a
later time. I think my API CMD-260's will run the current steppers
without a problem.
Thanx,
Doug
diag of the rear panel enclosure? Also, when looking at the terminal
block I see the motor outputs (X1 X2 X3 X4 X5 & X5 again) same for Y
and Z - does anyone that has done a retrofit know the motor coil
pinouts?
For all that are interested I plan to completly document this
retrofit and post it here for all to use. My current plan is to reuse
the steppers and the coolant systems and then retrofit servos at a
later time. I think my API CMD-260's will run the current steppers
without a problem.
Thanx,
Doug
Discussion Thread
dougfennell2000
2003-08-06 14:15:07 UTC
Brifgeport Series II help
Tim
2003-08-07 00:02:48 UTC
Re: Brifgeport Series II help
dougfennell2000
2003-08-07 04:56:04 UTC
Re: Brifgeport Series II help
Pat
2003-08-09 07:11:16 UTC
Re: Brifgeport Series II help