Re: Servo issue
Posted by
dakota8833
on 2003-08-14 06:04:12 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "Jason Cox" <sinergy@o...> wrote:
be broke, loose etc. I'ld remove them and have a look. And do your
rotation test again with them removed.
Frank
> Jon and all,which worked
>
> Heres what I did. First swapped other motors on the same g320's
> fine, so Im assuming that it is the motor only.terminals as
>
> It spins freely with nothig connected but when I connected the
> you said it felt smooth and consistent for whole rotationsclockwise, but
> when anti clockwise I can feel a very light cogging, it does nothowever get
> easy in one part or the rotation.turning
>
> I did this same test on another motor and it was smooth both ways.
>
> I also tested the motor at 90deg intervals with no change in its anti
> clockwise weakness!
>
> If this motor has a high number of windings could this cogging when
> be an open winding? But would I feel this in only one direction?Or could
>
> The main thing is could this be the cause of my x axis going crazy?
> it have been my crazy x axis that drove itself into the stops andoverheated
> the motor?except that
>
> Could I be getting noise or something from the computer, this worries me
> cause all has worked fine for six months and nothing has changed
> I overheated the motor but still which came first the chicken or theegg?
>Jason , You may have a problem with one of the brushes/holder. Could
> I hope this makes some sort of sense to you?
>
> Thanks for all of your help.
>
> Regards,
>
> Jason Cox.
be broke, loose etc. I'ld remove them and have a look. And do your
rotation test again with them removed.
Frank
Discussion Thread
Jason Cox
2003-08-11 21:53:15 UTC
Servo issue
mmurray701
2003-08-11 23:12:51 UTC
Re: Servo issue
Jon Elson
2003-08-12 10:35:16 UTC
Re: [CAD_CAM_EDM_DRO] Servo issue
Jason Cox
2003-08-13 16:44:27 UTC
Re: [CAD_CAM_EDM_DRO] Servo issue
Jon Elson
2003-08-13 22:32:32 UTC
Re: [CAD_CAM_EDM_DRO] Servo issue
Jason Cox
2003-08-14 00:48:51 UTC
Re: [CAD_CAM_EDM_DRO] Servo issue
dakota8833
2003-08-14 06:04:12 UTC
Re: Servo issue
Jon Elson
2003-08-14 10:02:21 UTC
Re: [CAD_CAM_EDM_DRO] Servo issue
Peter L. Peres
2003-08-14 20:03:20 UTC
Re: [CAD_CAM_EDM_DRO] Servo issue