cfg file for stepperwprld sp3-ht

i realize this may not be exactly the right board for this question
but i cant even get a "go away" from the turbocnc board so here i
will try.
can anyone here send me a cfg file for turbocnc to interface with a
stepperworld sp3-ht board ? feeds and such dont matter to me at this
point, i would just like to get turbocnc to move my motors enuf that
i could evaluate it. I must be missing something obvious in the setup
as it wont do anything. I can run them with kcam and i can gget the
to do whatever i want with cncpro. I would really like to see this
turbocnc in action since it is so cheap. I only do 2d right now so if
possible i would rather spend 20 rather than 200. Maybe there is an
enable that i am not getting. I am lost can anyone help?

Thanks

Ricky