FS: 3 SD200 Drives with DeskCNC
Posted by
Fred Smith
on 2003-08-20 17:29:32 UTC
I have QTY 3, New-unused, SD200 Superior Electric Step Motor Drives.
These are full or half step, 2.5 amp up to 40 volts.
http://www.slosyn.com/ssstepdrives_sd200.html
See connection:
http://www.slosyn.com/manuals/SD200%20Connect.pdf
and instruction manuals:
http://www.slosyn.com/manuals/SD200%20Instruction%20Manual.pdf
These may be purchased for $35 each if purchased with a DeskCNC
software and controller board.
Total of $430 for all items, including shipping to USA or Canada.
First contact with a valid credit card (V-M-AX) takes all three.
Fred Smith - IMService
imserv AT imsrv.com
888-451-1670 Toll Free in USA and Canada
248-486-3600
Fax:248-486-3698
Our voice mail is time stamped, as are the fax and e-mail.
These are full or half step, 2.5 amp up to 40 volts.
http://www.slosyn.com/ssstepdrives_sd200.html
See connection:
http://www.slosyn.com/manuals/SD200%20Connect.pdf
and instruction manuals:
http://www.slosyn.com/manuals/SD200%20Instruction%20Manual.pdf
These may be purchased for $35 each if purchased with a DeskCNC
software and controller board.
Total of $430 for all items, including shipping to USA or Canada.
First contact with a valid credit card (V-M-AX) takes all three.
Fred Smith - IMService
imserv AT imsrv.com
888-451-1670 Toll Free in USA and Canada
248-486-3600
Fax:248-486-3698
Our voice mail is time stamped, as are the fax and e-mail.