Re: Netmos/Linux/EMC??

I can insert the modules to install the card, but my problem is that
the card is automatically configuring itself for 0xac00. I can't (or
don't know how to) change the card configuration.
looking at /proc/pci I can see that the card is:
Bus 0, device 20, function 0, irq 10
I/O at 0xac00 [0xac01] <this is supposed to be the port i/o
I/O at 0xb000 [0xb001] <this is supposed to be the ecp/epp register
the rest are not used
If there is a way to reset the card to 0x278 please let me know

Thanks,
Dean

--- In CAD_CAM_EDM_DRO@yahoogroups.com, Paul <no.spam27@n...> wrote:
>
> Hi Dean
>
> Sure you can use a PCI parallel port card with EMC - I have one
plugged in
> here without any problems.
> The trick is to determine the correct IO address to use. I'd
suggest looking
> at /proc/pci and look for IO addresses for a communications
controller. Cross
> referencing them with /proc/ioports might help in identifying the
correct one
> to use.
>
> pci-utils was added to BDI-2.18 to enable some people to do some
development
> work. It is not a prerequisite program that *must* be installed
before any
> PCI card can be used. All it does is interrogate PCI cards and
provide
> additional information.
>
> Regards, Paul.
>