Help! Home Made CNC
Posted by
surfbuilder2003
on 2003-08-21 14:11:30 UTC
I am looking for plans or info on how to build a gantry type of
router table with an envelope of 8' long, 28" wide by 16" tall. I am
very new and inexperienced with the CNC system. I am very literate
with computers, hardware and software. Any information on how to put
together an inexpensive router would be appreciated. I will be using
it to cut out foam so being very precise is not my main concern, I
will be hand finishing with sand paper. Any information will be most
appreciated.
Thanks
Mike
router table with an envelope of 8' long, 28" wide by 16" tall. I am
very new and inexperienced with the CNC system. I am very literate
with computers, hardware and software. Any information on how to put
together an inexpensive router would be appreciated. I will be using
it to cut out foam so being very precise is not my main concern, I
will be hand finishing with sand paper. Any information will be most
appreciated.
Thanks
Mike