Re: [CAD_CAM_EDM_DRO] Re: Netmos/Linux/EMC??
Posted by
Thomas Fritz
on 2003-08-21 16:58:35 UTC
Matt Shaver wrote:
EMC...you should look for BASE_IO_ADDRESS, which you will find in
probably two different sections of the the .ini file you're using...I'm
using the latest version of EMC, and I'm working with the stepper.ini
(already set up with everything for parport and steppers)
>PARPORT_IO_ADDRESS has been depreciated in the later versions of
> ; section for main IO controller parameters
> [EMCIO]
>
> <other parameters are in here also...>
>
> ; address for parallel port used for auxiliary IO
> PARPORT_IO_ADDRESS = 0xac00
>
> Matt
>
>
EMC...you should look for BASE_IO_ADDRESS, which you will find in
probably two different sections of the the .ini file you're using...I'm
using the latest version of EMC, and I'm working with the stepper.ini
(already set up with everything for parport and steppers)
Discussion Thread
foxprints2003
2003-08-20 15:14:03 UTC
Netmos/Linux/EMC??
Paul
2003-08-20 16:48:02 UTC
Re: [CAD_CAM_EDM_DRO] Netmos/Linux/EMC??
foxprints2003
2003-08-20 17:08:04 UTC
Re: Netmos/Linux/EMC??
Matt Shaver
2003-08-20 20:55:49 UTC
Re: [CAD_CAM_EDM_DRO] Re: Netmos/Linux/EMC??
foxprints2003
2003-08-21 08:23:07 UTC
Re: Netmos/Linux/EMC??
Thomas Fritz
2003-08-21 16:58:35 UTC
Re: [CAD_CAM_EDM_DRO] Re: Netmos/Linux/EMC??
foxprints2003
2003-08-22 04:11:23 UTC
Re: Netmos/Linux/EMC??
Ray Henry
2003-08-22 15:36:05 UTC
Re: Re: Netmos/Linux/EMC??