Re: [CAD_CAM_EDM_DRO] CNC self teach

Listed at the end of each of our group email's is a list of links that will
get you fast moving on the path to CNC.
I would start by reading each and every document on Tim Goldstein's site:
http://www.timgoldstein.com/cad_cam/cadfaq.asp
There are many other sites with fantastic info but you need to spend the
time to read....
http://www.control.com/
http://www.linuxcnc.org/
http://www.angelfire.com/az2/proff/
http://www.ab.com/motion/

Then cover anything interesting to you in the files section at Yahoo.com

FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/

Before you know it you'll be watching chips fly and have only lint in your
pocketbook. :)

Vince

----- Original Message -----
From: "Thomas Powell" <tppjr@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Wednesday, September 03, 2003 12:58 PM
Subject: [CAD_CAM_EDM_DRO] CNC self teach


> Time to get boned up on all this CNC stuff. Is there somewhere or where
is
> the best place I can go to find out all the ends and outs, dos and don'ts
so
> when I go to CNC my RF-45 I don't go into it blind.
>
> Stuff like, stepper types, number of wires used for what, which are better
> for what. Power supplies, where to get what type, volts, amps.
> Controllers, uni-polar, bi-polar ???????
>
> Thanks for any and all info.
> ====================================
> Thomas Powell (VMOA 741)
> 1994 NOS injected T-Boost sales
> Tourmaster V-Max Clear clutch cover sales
> "LAFGAS" Handlebar brackets
> tppjr@...
> http://imageevent.com/tppjr (photopage)
> ====================================