Is this Servo good for CNC Router ?

I was wondering is the servo motor listed below might be good for a
really beefy CNC router? I know it could handle the torque, but what
about the speed? They can use the low-cost Geckodrive G320 and G340
Servo drives. What do you think? Any opinions appreciated!

Reliance Electric DC Brushed Servo Motors, Model E712
37.51 Oz-In/A
25.0-30.5 V/KRpm
Motor Terminal Resistance .75-1.02 Ohms @ 4A.
Maximum Terminal Voltage 60V
Maximum Continuous Speed 2100 RPM (No Load)
Maximum Peak Torque 1500 Oz-In.
Maximum Peak Current 44.5A
Maximum Continuous Stall Torque At Max Motor Temp 300 Oz-In.
Maximum Continuous Current 8.9A
Electro-Craft brush-type DC servomotors