Re: [CAD_CAM_EDM_DRO] DESKNCRT UPDATE

Dan,

You have my juices running.

To put it bluntly, I am moist with anticipation.

Keep us up to date.

Paul

----- Original Message -----
From: Dan Mauch <dmauch@...>
To: <CAD_CAM_EDM_DRO@onelist.com>
Sent: Friday, March 24, 2000 2:19 PM
Subject: Re: [CAD_CAM_EDM_DRO] DESKNCRT UPDATE


> From: "Dan Mauch" <dmauch@...>
>
> I have been running the latest version of deskncrt with stepper motor
> feedback disabled(DOS) and it is doing very, very well. Carl has fixed
most
> of the bugs. I have been able to set it up so that the Pentium 200 can run
> the steppers faster than they can run. It looks like it will run systems
at
> very high speeds if they are capable of running at high speed.
> I also loaded it onto a 486-66 and set the max velocity to 50 IPM and it
> seemed to run great. I have had nothing but problems with the earlier
> version of this program on this machine so I was delighted to see it run
so
> well on the 486-66.
> There are a few new bugs that need to be fixed. One is that the abort
> doesn't work promptly. The other is that it if the program stops due to a
> limits error and you type enable again the machine takes off running to
only
> it knows where. Again these were not problems with the earlier version so
> I.m sure it will be readily fixable.
> I hope to add some encoders and one of my DRO boards to see how the
feedback
> works over the weekend.
> Stay tuned for further updates.
> Dan
>
>
>
> ------------------------------------------------------------------------
> PERFORM CPR ON YOUR APR!
> Get a NextCard Visa, in 30 seconds! Get rates as low as
> 0.0% Intro or 9.9% Fixed APR and no hidden fees.
> Apply NOW!
> http://click.egroups.com/1/2121/2/_/423600/_/953925660/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
>