Re: [CAD_CAM_EDM_DRO] Variable speed on CNC router

I'm not exactly sure your question, but my X-Y table uses a Harbor Freight
trim router (19.95 on sale). I use a variac to adjust it's speed. Can get
it going from too slow to faster than if plugged in directly into the wall.

- Steven Ciciora

At 06:12 PM 10/7/2003 +0000, you wrote:

>Has any one fitted a homwbrew CNC router with variable speed. Other
>than using a dimmer switch. I assume I will loose some HP at the
>router since the dimmer uses about 18 gauge wiring.