Wow! was Re: Cheap Servo Motor?
Posted by
Randy Gordon-Gilmore
on 2003-10-07 15:54:25 UTC
At 09:39 PM 10/7/2003 -0000, Mariss wrote:
Wow! Wow!
When did Surplus Center put up a website?!? They're a great place to pick
up parts for the obligatory CAD/CAM content but have always been limited to
the slow paper catalog (and the KB controllers are always out of stock by
the time I get my copy...)
Best regards,
Randy (a Lincoln native, so I used to ride my bike out to their store as a
teen)
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.prototrains.com
>blah blah blah http://www.surpluscenter.com/ blah blah blah...a rough paraphrase :-)
Wow! Wow!
When did Surplus Center put up a website?!? They're a great place to pick
up parts for the obligatory CAD/CAM content but have always been limited to
the slow paper catalog (and the KB controllers are always out of stock by
the time I get my copy...)
Best regards,
Randy (a Lincoln native, so I used to ride my bike out to their store as a
teen)
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.prototrains.com
Discussion Thread
Mariss Freimanis
2003-10-07 14:39:06 UTC
Cheap Servo Motor?
Randy Gordon-Gilmore
2003-10-07 15:54:25 UTC
Wow! was Re: Cheap Servo Motor?
Jon Elson
2003-10-07 23:05:34 UTC
Re: [CAD_CAM_EDM_DRO] Cheap Servo Motor?
Dan Mauch
2003-10-08 08:03:39 UTC
Cute micro lathe video
Marv Frankel
2003-10-08 10:01:39 UTC
Re: [CAD_CAM_EDM_DRO] Cute micro lathe video
mmeyers1111
2003-10-08 17:17:41 UTC
Re: Cheap Servo Motor?
Dan
2003-10-08 17:18:33 UTC
Re: [CAD_CAM_EDM_DRO] Cute micro lathe video
Graham Stabler
2003-10-08 18:03:31 UTC
Re: Cute micro lathe video
Harvey White
2003-10-08 19:53:10 UTC
Re: [CAD_CAM_EDM_DRO] Re: Cute micro lathe video
Leslie M. Watts
2003-10-09 06:18:24 UTC
RE: [CAD_CAM_EDM_DRO] Re: Cheap Servo Motor?
Terry Owens
2003-10-09 10:15:44 UTC
Re: [CAD_CAM_EDM_DRO] Re: Cute micro lathe video