Re: [CAD_CAM_EDM_DRO] 4th axis rotary table project
Posted by
Larry Van Duyn
on 2003-10-21 05:22:05 UTC
Hello Rick
Monday, October 20, 2003, 7:40:48 PM, you wrote:
s> Well, I went ahead and got the phase II 10 inch rotary table
s> (horizontal and vertical) from enco for $249. Seemed like a decent
s> deal. I will be adding either a stepper or servo to it and using it
s> as a fourth axis on my bedmill. I am interested in hearing of others
s> who have done this with a phase II or similar rotary table. For
s> example, do you need to have an air solinoid or something on the
s> table lock or is the 90:1 worm gear good enough to hold the table in
s> position while drilling or cutting gear teeth?
s> Thanks,
s> Rick
I have done axactly that and there are some pics in the photo
section of this forum in the folder called K8JBL. I just
tried to access the photo section and all I can get from
yahoo is an "error message"
Best regards,
Larry
Monday, October 20, 2003, 7:40:48 PM, you wrote:
s> Well, I went ahead and got the phase II 10 inch rotary table
s> (horizontal and vertical) from enco for $249. Seemed like a decent
s> deal. I will be adding either a stepper or servo to it and using it
s> as a fourth axis on my bedmill. I am interested in hearing of others
s> who have done this with a phase II or similar rotary table. For
s> example, do you need to have an air solinoid or something on the
s> table lock or is the 90:1 worm gear good enough to hold the table in
s> position while drilling or cutting gear teeth?
s> Thanks,
s> Rick
I have done axactly that and there are some pics in the photo
section of this forum in the folder called K8JBL. I just
tried to access the photo section and all I can get from
yahoo is an "error message"
Best regards,
Larry
Discussion Thread
skykotech
2003-10-20 20:42:40 UTC
4th axis rotary table project
Larry Van Duyn
2003-10-21 05:22:05 UTC
Re: [CAD_CAM_EDM_DRO] 4th axis rotary table project
stevenson_engineers
2003-10-21 07:10:31 UTC
Re: 4th axis rotary table project
Wkuehsel@a...
2003-10-23 05:10:07 UTC
Re: [CAD_CAM_EDM_DRO] 4th axis rotary table project