Re: [CAD_CAM_EDM_DRO] Re: Cable stuff
Posted by
zephyrus@r...
on 2003-11-02 14:25:14 UTC
At 09:34 PM 11/2/03 -0000, Ballendo wrote:
series), 4+ million cycles and torsion service (I don't remember which the
71xx and 72xx are since they have changed all the series numbers in the
last year or two, and my old catalog is at work) but I figure any of them
should be OK for home use...
I'm using Infinity 7002 4-conductor 20-gage on my Sherlines and it is nice
cable. I got it from Mendelson Electronics (http://www.meci.com) but they
have sold out of almost all their Infinity selection.
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.prototrains.com
>I can't tell from the link-ed list... But keep in mind that not allI didn't know that, Ballendo.
>Olflex cable is motion rated...
>Don't have my Belden catalog handy, and don't know if all infinityYes, it is. There are different series for 1+ million cycles (70xx
>cable is motion control rated?
series), 4+ million cycles and torsion service (I don't remember which the
71xx and 72xx are since they have changed all the series numbers in the
last year or two, and my old catalog is at work) but I figure any of them
should be OK for home use...
I'm using Infinity 7002 4-conductor 20-gage on my Sherlines and it is nice
cable. I got it from Mendelson Electronics (http://www.meci.com) but they
have sold out of almost all their Infinity selection.
Best regards,
Randy
Randy Gordon-Gilmore ,----.___________ ______________ _________________
ProtoTrains // = = === == || == == == = || == == == = == =|
Rio Vista, CA, USA /-O==O------------o==o------------o==o-----------o==o-'
zephyrus@... http://www.prototrains.com
Discussion Thread
walldawg1
2003-11-01 15:53:16 UTC
Stuttering stepper
Jon Elson
2003-11-01 22:40:29 UTC
Re: [CAD_CAM_EDM_DRO] Stuttering stepper
ballendo
2003-11-02 04:42:08 UTC
Cable stuff was Re: Stuttering stepper
turbulatordude
2003-11-02 07:34:03 UTC
Cable stuff was Re: Stuttering stepper- cables and flex
zephyrus@r...
2003-11-02 09:39:07 UTC
Re: Cable stuff
ballendo
2003-11-02 13:34:18 UTC
Re: Cable stuff
zephyrus@r...
2003-11-02 14:25:14 UTC
Re: [CAD_CAM_EDM_DRO] Re: Cable stuff
JanRwl@A...
2003-11-02 17:22:35 UTC
Re: [CAD_CAM_EDM_DRO] Stuttering stepper