CAD CAM EDM DRO - Yahoo Group Archive

Re: Mini Mill Shopping - Desk CNC

on 2003-11-19 08:00:34 UTC
> DeskCNC works just fine with any of the step and direction
drivers.
> You just insert the signal wires into the terminals on the
controller
> board, instead of into the parallel port.
>
> In fact, because of the low signal levels found on many laptop
> parallel ports, DeskCNC works better than many parallel port driven
> systems (besides other advantages).
>
> It does provide a breakout board function, which is usually needed
> for a parallel port system at extra cost.
>
> Best Regards, Fred Smith- IMService
>
> Listserve Special discounts and offers are at:
> http://www.imsrv.com/hobby


Hi Fred,

I looked at the Desk CNC page and found the flow chart link.
http://www.imsrv.com/deskcnc/

seems you offer a RS232 or USB connection and that the board might be
a controller/driver board in as much as it is generating the pulses
(or phases) to operate the motors.

It seems this is a potential software for PCB routing/drilling, which
is my purpose.

I didn't understand the 'NO LONGER AVAILABLE' comment about the
driver board. I would assume this is integral to the system ?

Also, is there a data sheet that lists step rates and stuff ?

Dave

Discussion Thread

sharkonwheels 2003-11-18 09:20:48 UTC Mini Mill Shopping turbulatordude 2003-11-18 14:09:53 UTC Re: Mini Mill Shopping Garry & Maxine Foster 2003-11-18 16:06:07 UTC Re: [CAD_CAM_EDM_DRO] Mini Mill Shopping turbulatordude 2003-11-18 20:04:22 UTC Re: Mini Mill Shopping Tony Mori 2003-11-18 21:34:23 UTC Re: [CAD_CAM_EDM_DRO] Re: Mini Mill Shopping Mike Hammel 2003-11-18 22:15:34 UTC Re: [CAD_CAM_EDM_DRO] Re: Mini Mill Shopping Tony Mori 2003-11-18 23:12:40 UTC Re: [CAD_CAM_EDM_DRO] Re: Mini Mill Shopping Fred Smith 2003-11-19 02:31:58 UTC Re: Mini Mill Shopping turbulatordude 2003-11-19 08:00:34 UTC Re: Mini Mill Shopping - Desk CNC Fred Smith 2003-11-19 15:36:34 UTC Re: Mini Mill Shopping - Desk CNC William Scalione 2003-11-19 17:02:19 UTC Re: [CAD_CAM_EDM_DRO] Re: Mini Mill Shopping - Desk CNC Fred Smith 2003-11-20 06:37:45 UTC Re: Mini Mill Shopping - Desk CNC