help needed

ok , i dont want to be a pain in the you know what but i have read
past messages till i am seeing double and i am still not sure that i
have planned my upcoming cnc conversion properly and i need to spend
only once as i am kinda poor like most are.
my plans.................for a van norman no 12 with knee only ( no
quill ). i may later take all this off to put on a bridgeport clone
or a lagun i have my eye on.

gecko320
campbell breakout board
68 volt 15 amp or so power supply
reliance E712 servo motor ( i have these already + the encoders )
renco encoder 1024 ppr
3 to 1 reduction on x and y ( 5 turns per inch )
4 to one reduction on z ( 10 turns per inch and heavy )
mach 2 mill
new computer ( built by me from parts i buy or have on hand )

i know i need limit switches and such also.

if anyone is capable and willing to help me by direct e mail i will
gladly pay a small consultant fee to insure i get this right the
first time.
don thigpen
piggy at accessatc.net