Re: [CAD_CAM_EDM_DRO] what type of end mill for engraving

Les,

Most fine engraving is done with an engraving bit. It looks like a V bit,
but can have a flat on the end. The flat is there if you are going to do a
lot of fill (pocketing)
Bob Campbell
http://www.campbelldesigns.com
Breakout Boards
VisualMill 5.0 basic

----- Original Message -----
From: "lum_l" <lum_l@...>
To: <CAD_CAM_EDM_DRO@yahoogroups.com>
Sent: Thursday, November 27, 2003 7:03 PM
Subject: [CAD_CAM_EDM_DRO] what type of end mill for engraving


> Hi All,
>
> What type of end mill should I use for engraving. I tried a 3mm ball
> end mill, but it makes the lines too thick.
>
> Thanks,
>
> Les
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe: CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe: CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com, wanliker@...,
timg@...
> Moderator: pentam@... indigo_red@... [Moderators]
> URL to this group: http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
aol://5863:126/rec.crafts.metalworking or go thru Google.com to reach it if
you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I consider this to be a
sister site to the CCED group, as many of the same members are there, for OT
subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC DOMAIN BY POSTING THEM.
DON'T POST IF YOU CAN NOT ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>