Lathe kit
Posted by
riaanbarnard2000
on 2003-11-30 12:13:59 UTC
Hi
I have a Denford Easyturn CNC lathe and would like to upgrade the
complete cnc unit.
Can someone please give a list of the equipment required. i would
like to upgrade from stepper to servo motors. What kind of
cards,drives,amps and PSU do I need.What happens to the auxcillary
input/outputs and how are the controlled.What software should I use.
I dont mind spending a few dollars on good equipment and software. Do
I need a full pc with a special card or can I run the software on a
second hand laptop of some sort.
I would realy like to get the best system for a budget of 2000-2500
dollars.
Kind Regards
Riaan
I have a Denford Easyturn CNC lathe and would like to upgrade the
complete cnc unit.
Can someone please give a list of the equipment required. i would
like to upgrade from stepper to servo motors. What kind of
cards,drives,amps and PSU do I need.What happens to the auxcillary
input/outputs and how are the controlled.What software should I use.
I dont mind spending a few dollars on good equipment and software. Do
I need a full pc with a special card or can I run the software on a
second hand laptop of some sort.
I would realy like to get the best system for a budget of 2000-2500
dollars.
Kind Regards
Riaan