Re: [CAD_CAM_EDM_DRO] "newbie" ?? about steppers, servos

tldj55 wrote:

>Anyway, this ?? has
>probably been asked before, but please point in me in the right
>direction.
>

Tom, this is a favorite question on this list. Usually, the advice is
to go thru the FAQ listed below. Sooner or later you will run into the
URL for Gecko Drives and Marriss has done a very good job on motors.
Unfortunately, there are dozens of books out there and many won't suit
you. So I suggest you start here with the FAQ. You will also come
accross a way to search the archives and everything is in there
somewhere, but harder to comprehend because the posts are not always
flowing along the idea denoted by the subject header.

JerryK