Re: [CAD_CAM_EDM_DRO] Hacking into the DRO's output

I have some ideas using micro controller prammer
software.

--- taz_the_goat <tzeiger@...> wrote:

> Is is posible to use the quatrature output of the
> DRO slide to
> provide feedback to the controller? I figure this
> would be better
> then running open loop with steppers, or reading
> position directly
> from the servo motors because of the backlash/slop
> in the leads
> screws.
>
> Anyone try this? This is for a RF-31 w/ DRO from
> enco. Sorry if this
> has been covered before, I'm new :)
>
> -Ted
>
>
>
> Addresses:
> FAQ: http://www.ktmarketing.com/faq.html
> FILES:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO/files/
> Post Messages: CAD_CAM_EDM_DRO@yahoogroups.com
>
> Subscribe:
> CAD_CAM_EDM_DRO-subscribe@yahoogroups.com
> Unsubscribe:
> CAD_CAM_EDM_DRO-unsubscribe@yahoogroups.com
> List owner: CAD_CAM_EDM_DRO-owner@yahoogroups.com,
> wanliker@..., timg@...
> Moderator: pentam@... indigo_red@...
> [Moderators]
> URL to this group:
> http://groups.yahoo.com/group/CAD_CAM_EDM_DRO
>
> OFF Topic POSTS: General Machining
> If you wish to post on unlimited OT subjects goto:
> aol://5863:126/rec.crafts.metalworking or go thru
> Google.com to reach it if you have trouble.
> http://www.metalworking.com/news_servers.html
>
> http://groups.yahoo.com/group/jobshophomeshop I
> consider this to be a sister site to the CCED group,
> as many of the same members are there, for OT
> subjects, that are not allowed on the CCED list.
>
> NOTICE: ALL POSTINGS TO THIS GROUP BECOME PUBLIC
> DOMAIN BY POSTING THEM. DON'T POST IF YOU CAN NOT
> ACCEPT THIS.....NO EXCEPTIONS........
> bill
> List Mom
> List Owner
>
>
>
> Your use of Yahoo! Groups is subject to
> http://docs.yahoo.com/info/terms/
>
>

__________________________________
Do you Yahoo!?
New Yahoo! Photos - easier uploading and sharing.
http://photos.yahoo.com/