Re: [CAD_CAM_EDM_DRO] Controler Software
Posted by
wanliker@a...
on 2003-12-20 17:36:14 UTC
In a message dated 12/20/2003 1:42:06 PM Mountain Standard Time,
tsomer2003@... writes:
I'd like your opinions:
What is the most economical and stable controler?
For very low cost and stability until you get everything sorted out Use DOS
6.22 and TurboCNC. This will get things running and you can go from there.
bill
[Non-text portions of this message have been removed]
tsomer2003@... writes:
I'd like your opinions:
What is the most economical and stable controler?
For very low cost and stability until you get everything sorted out Use DOS
6.22 and TurboCNC. This will get things running and you can go from there.
bill
[Non-text portions of this message have been removed]
Discussion Thread
tsomer2003
2003-12-20 12:39:03 UTC
Controler Software
wanliker@a...
2003-12-20 17:36:14 UTC
Re: [CAD_CAM_EDM_DRO] Controler Software
washcomp
2003-12-20 17:54:29 UTC
Re: Controler Software
Fred Smith
2003-12-21 14:49:51 UTC
Re: Controler Software