Re: deskcnc servo driver
Posted by
bull2003winkle
on 2003-12-29 10:59:48 UTC
Jon:
No doubt about it, I need a new caculator. Thanks for the correction.
Ken
No doubt about it, I need a new caculator. Thanks for the correction.
Ken
> Huh? You'd better check your calculations. If the encoder gives 500multi-axis
> counts/rev,
> times 5 for the ballscrew, that is 2500 counts/inch, or .0004"/count.
> 0.0004" x 128 = 0.0512", 51 thousandths. If that happens during
> cutting, I'm sure a lot of people would notice the error.
>
> Even if you meant 500 cycle/rev on the encoders, giving 2000 counts/rev,
> the error would still be 0.0128", which might be a lot, depending on the
> work in question.
>
> Jon
Discussion Thread
stcnc2000
2003-12-27 18:53:36 UTC
deskcnc servo driver
Fred Smith
2003-12-28 00:54:23 UTC
Re: deskcnc servo driver
Gregory Kamysz
2003-12-28 10:05:48 UTC
Re: [CAD_CAM_EDM_DRO] Re: deskcnc servo driver
Fred Smith
2003-12-28 19:34:04 UTC
Re: deskcnc servo driver
Jon Elson
2003-12-28 20:52:30 UTC
Re: [CAD_CAM_EDM_DRO] Re: deskcnc servo driver
Gregory Kamysz
2003-12-28 21:54:24 UTC
Re: [CAD_CAM_EDM_DRO] Re: deskcnc servo driver
bull2003winkle
2003-12-28 23:07:21 UTC
Re: deskcnc servo driver
Jon Elson
2003-12-29 09:02:37 UTC
Re: [CAD_CAM_EDM_DRO] Re: deskcnc servo driver
Jon Elson
2003-12-29 09:08:10 UTC
Re: [CAD_CAM_EDM_DRO] Re: deskcnc servo driver
bull2003winkle
2003-12-29 10:59:48 UTC
Re: deskcnc servo driver
caudlet
2003-12-30 09:06:48 UTC
Re: deskcnc servo driver