Gecko 320 not pulsing
Posted by
callcbm2000
on 2003-12-30 09:17:06 UTC
The motors stop turning and are singing with no faults . The wireing
to the motors had to be reversed. Thanks for the info. But now the
interfaced board is not pulsing or turning the motors. the board is a
PMDX -120 . All the contacts work with the software which is master 5
Tne motors are minerta rm servo . I beleive the size are some what
adequate when the motors where wire backwards they move the gantry
fine.I have set the dim switches to demo mode and still nothing
happens I wired as the paper work stated.
to the motors had to be reversed. Thanks for the info. But now the
interfaced board is not pulsing or turning the motors. the board is a
PMDX -120 . All the contacts work with the software which is master 5
Tne motors are minerta rm servo . I beleive the size are some what
adequate when the motors where wire backwards they move the gantry
fine.I have set the dim switches to demo mode and still nothing
happens I wired as the paper work stated.
Discussion Thread
callcbm2000
2003-12-30 09:17:06 UTC
Gecko 320 not pulsing
Lee Studley
2003-12-30 11:44:34 UTC
Re: Gecko 320 not pulsing
Jon Elson
2003-12-30 20:29:05 UTC
Re: [CAD_CAM_EDM_DRO] Re: Gecko 320 not pulsing
Lee Studley
2003-12-31 08:29:41 UTC
Re: Gecko 320 not pulsing