Re: Help with comunication RS232 to RS-244-A
Posted by
jlsmith269
on 2004-01-20 20:17:57 UTC
rs244 is still serial. there is NO way to take a serial transmission
(one bit wide) and convert to parallel (8 bits wide) without an IO
board, asic, or some other form of layer 6 device, per the OSI model.
http://www.cimnet-folders.com/hardware_1.htm
but, it's all good, and it can be done.
jeffe
(one bit wide) and convert to parallel (8 bits wide) without an IO
board, asic, or some other form of layer 6 device, per the OSI model.
http://www.cimnet-folders.com/hardware_1.htm
but, it's all good, and it can be done.
jeffe
--- In CAD_CAM_EDM_DRO@yahoogroups.com, Yesamazza@a... wrote:
> HI
> I have an old CNC lathe with a Yasnac 2000G controller. The
lathe works
> well and I can write programs manually with the key pad. I would
like to send
> and receive programs into its memory through its Tape reader port
(DB25). It
> has a 4k character electronic memory but the communication port is
for a tape
> reader and uses all 25 pins of a 25pin connector is there a
translator I can
> use to send RS232 to a EIA RS-244-A or ISO R840 ?. I would assume
that RS-232
> is serial and RS-244 is parallel bit transfer is this correct? What
are these
> standards and are there programs that I can configure to send info
like the
> tape reader would? What are my options? I have a tape
reader/puncher also but
> of course would like to eliminate its use. Any info Links ect
greatly
> appreciated.
>
>
> [Non-text portions of this message have been removed]
Discussion Thread
Yesamazza@a...
2004-01-20 19:53:38 UTC
Help with comunication RS232 to RS-244-A
jlsmith269
2004-01-20 20:17:57 UTC
Re: Help with comunication RS232 to RS-244-A
Jon Elson
2004-01-20 22:46:38 UTC
Re: [CAD_CAM_EDM_DRO] Help with comunication RS232 to RS-244-A