Re: [CAD_CAM_EDM_DRO] Bport Tachometer
Posted by
Gary Hart
on 2004-01-28 18:25:03 UTC
Jack,
What worked for me was to make a draw bar with extended hex, enough hex so
some is sticking up when the quill is all the way done. Then set sensor to
read of the peaks of the hex. Been working good for me, if you like I
could email picture....................... gary
What worked for me was to make a draw bar with extended hex, enough hex so
some is sticking up when the quill is all the way done. Then set sensor to
read of the peaks of the hex. Been working good for me, if you like I
could email picture....................... gary
> Has anyone installed a magnetic pickup for digital tachometer on a
> Bport Type I J-head?
>> Jack
>
>
>
Discussion Thread
jackw19x
2004-01-28 11:19:43 UTC
Bport Tachometer
jackw19x
2004-01-28 12:20:46 UTC
Bport Tachometer
Gary Hart
2004-01-28 18:25:03 UTC
Re: [CAD_CAM_EDM_DRO] Bport Tachometer
Jon Elson
2004-01-28 21:11:00 UTC
Re: [CAD_CAM_EDM_DRO] Bport Tachometer
jackw19x
2004-01-30 16:01:10 UTC
Re: Bport Tachometer