Re: [CAD_CAM_EDM_DRO] brushless servo amp
Posted by
paul@a...
on 2000-04-10 12:02:49 UTC
OK, I got it.
thanks
Paul Amaranth | Rochester MI, USA
Aurora Group, Inc. | Systems & Software
paul@... | Unix / Windows / NT
thanks
>--
> its a big page (11x17") you'll have to set your ps viewer to
> orientation=landscape
> media=tabloid
> this works for me on ghostscript
> http://www.cs.wisc.edu/~ghost/
>
> ----- Original Message -----
> From: <paul@...>
> To: <CAD_CAM_EDM_DRO@egroups.com>
> Sent: Monday, April 10, 2000 8:20 AM
> Subject: Re: [CAD_CAM_EDM_DRO] brushless servo amp
>
>
> > Brian, the logic.ps is a bit truncated, it looks like it may have
> > been clipped to fit the page rather than scaled. Can you regenerate it?
> >
> > Paul
> >
> >
> > --
> > Paul Amaranth | Rochester MI, USA
> > Aurora Group, Inc. | Systems & Software
> > paul@... | Unix / Windows / NT
>
>
>
> ------------------------------------------------------------------------
> Special Offer-Earn 300 Points from MyPoints.com for trying @Backup
> Get automatic protection and access to your important computer files.
> Install today:
> http://click.egroups.com/1/2344/2/_/423600/_/955391821/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager
>
Paul Amaranth | Rochester MI, USA
Aurora Group, Inc. | Systems & Software
paul@... | Unix / Windows / NT
Discussion Thread
james owens
2000-04-10 10:36:55 UTC
Re: [CAD_CAM_EDM_DRO] brushless servo amp
bfp
2000-04-10 11:36:59 UTC
Re: [CAD_CAM_EDM_DRO] brushless servo amp
paul@a...
2000-04-10 12:02:49 UTC
Re: [CAD_CAM_EDM_DRO] brushless servo amp
Ernst Aardal
2000-05-14 12:50:24 UTC
Re: [CAD_CAM_EDM_DRO] brushless servo amp
bfp
2000-05-14 21:06:34 UTC
Re: [CAD_CAM_EDM_DRO] brushless servo amp