Re: [CAD_CAM_EDM_DRO] DRO Encoders
Posted by
Marshall Pharoah
on 2000-04-10 12:50:39 UTC
My cousin, who is a machinist, told me that his shop is using some
form of dial or digital readout which operates off a friction wheel
running on the sides op the mill table. He was going to check out
the brand and let me know.
He did say that they didn't seem to do anything special to guard
against chips, etc.
Marshall
form of dial or digital readout which operates off a friction wheel
running on the sides op the mill table. He was going to check out
the brand and let me know.
He did say that they didn't seem to do anything special to guard
against chips, etc.
Marshall
----- Original Message -----
From: james owens
To: CAD_CAM_EDM_DRO@egroups.com
Sent: Sunday, April 09, 2000 2:16 PM
Subject: Re: [CAD_CAM_EDM_DRO] DRO Encoders
This is food for thought. I had never considered using a rotary wheel and
friction. Yes I agree that the problem would be keeping the grot off the track but
it should be little trouble to enclose it all in an aluminium tube with sealed
ends. The errors in the mechanism could be programmed out after checking against a
known measure.
Discussion Thread
Larry Edington
2000-04-07 11:24:17 UTC
DRO Encoders
Tim Barnard
2000-04-07 11:42:02 UTC
RE: [CAD_CAM_EDM_DRO] DRO Encoders
james owens
2000-04-07 13:18:46 UTC
Re: [CAD_CAM_EDM_DRO] DRO Encoders
D.F.S.
2000-04-07 14:49:40 UTC
Re: [CAD_CAM_EDM_DRO] DRO Encoders
William Scalione
2000-04-07 15:04:38 UTC
Re: [CAD_CAM_EDM_DRO] DRO Encoders
Richard Gardner
2000-04-07 15:32:52 UTC
Re: [CAD_CAM_EDM_DRO] DRO Encoders
D.F.S.
2000-04-07 15:33:51 UTC
Re: [CAD_CAM_EDM_DRO] Linefeeds.
Jon Elson
2000-04-07 15:58:55 UTC
Re: [CAD_CAM_EDM_DRO] DRO Encoders
james owens
2000-04-07 16:02:11 UTC
Re: [CAD_CAM_EDM_DRO] DRO Encoders
Bertho Boman
2000-04-08 03:58:31 UTC
Re: [CAD_CAM_EDM_DRO] Linefeeds.
Bertho Boman
2000-04-08 04:42:56 UTC
Re: [CAD_CAM_EDM_DRO] Linefeeds.
Bertho Boman
2000-04-08 05:18:12 UTC
Re: [CAD_CAM_EDM_DRO] Linefeeds.
james owens
2000-04-09 11:15:22 UTC
Re: [CAD_CAM_EDM_DRO] DRO Encoders
David A. Forsyth
2000-04-10 02:02:48 UTC
Re: DRO Encoders
Marshall Pharoah
2000-04-10 12:50:39 UTC
Re: [CAD_CAM_EDM_DRO] DRO Encoders