Re: [CAD_CAM_EDM_DRO] How to build a CNC rotary table
Posted by
wanliker@a...
on 2004-01-30 14:57:32 UTC
In a message dated 1/30/2004 2:27:36 PM Mountain Standard Time,
emotorwerks@... writes:
similar to the Sherline rotary table where
you can enter data through a keypad device
I think that
sherlines piece is available. and also look up the Frog controller, can drive
small steppers enen make threading possible on a lathe.
check the FAQ.
bill
[Non-text portions of this message have been removed]
emotorwerks@... writes:
similar to the Sherline rotary table where
you can enter data through a keypad device
I think that
sherlines piece is available. and also look up the Frog controller, can drive
small steppers enen make threading possible on a lathe.
check the FAQ.
bill
[Non-text portions of this message have been removed]
Discussion Thread
emotorwerks
2004-01-30 13:24:10 UTC
How to build a CNC rotary table
Tony Jeffree
2004-01-30 13:37:18 UTC
Re: [CAD_CAM_EDM_DRO] How to build a CNC rotary table
Alan Marconett KM6VV
2004-01-30 14:37:51 UTC
Re: [CAD_CAM_EDM_DRO] How to build a CNC rotary table
wanliker@a...
2004-01-30 14:57:32 UTC
Re: [CAD_CAM_EDM_DRO] How to build a CNC rotary table
stevenson_engineers
2004-01-30 19:01:21 UTC
Re: How to build a CNC rotary table