RE: [CAD_CAM_EDM_DRO] Galil 600
Posted by
Harrison, Doug
on 2000-04-10 14:22:20 UTC
I have a Galil DMC-1000 which uses the same programming language. Galil
Basic is very powerful but rather difficult to convert to G-code. Galil
products are expensive and of excellent quality. Their support has
generally been good as well.
Doug Harrison
Basic is very powerful but rather difficult to convert to G-code. Galil
products are expensive and of excellent quality. Their support has
generally been good as well.
Doug Harrison
> -----Original Message-----
> From: Ward M. [SMTP:ward@...]
> Sent: Saturday, April 08, 2000 12:00 AM
> To: CAD_CAM_EDM_DRO@egroups.com
> Subject: [CAD_CAM_EDM_DRO] Galil 600
>
> Has anyone used a Galil model 600 motion control card? I may be getting
> one
> and am interested in finding out a little about it.
>
> Thanks,
>
> Ward M.
>
> ward@...
>
>
>
> ------------------------------------------------------------------------
> Get a NextCard Visa, in 30 seconds!
> 1. Fill in the brief application
> 2. Receive approval decision within 30 seconds
> 3. Get rates as low as 2.9% Intro or 9.9% Fixed APR
> Apply NOW!
> http://click.egroups.com/1/975/2/_/423600/_/955165944/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the
> discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager