Re: [CAD_CAM_EDM_DRO] Converting ORAC CNC Lathe
Posted by
Bob McKnight
on 2004-01-31 13:19:27 UTC
It would be helpful if people asking for help would
give some geographic information as to their location.
The other day, someone wanted to run some 115 volt
equipment on 220. They probably were not in the USA.
One of the replys was based on the USA power grid.
I hope other respondents, who recognized the possible
problem, averted problems for the gentleman. The more
information is provided to the group, the better the answer.
Bob McKnight Phoenix, Az USA
give some geographic information as to their location.
The other day, someone wanted to run some 115 volt
equipment on 220. They probably were not in the USA.
One of the replys was based on the USA power grid.
I hope other respondents, who recognized the possible
problem, averted problems for the gentleman. The more
information is provided to the group, the better the answer.
Bob McKnight Phoenix, Az USA
Discussion Thread
yours_salman2002
2004-01-31 10:37:41 UTC
Converting ORAC CNC Lathe
Bob McKnight
2004-01-31 13:19:27 UTC
Re: [CAD_CAM_EDM_DRO] Converting ORAC CNC Lathe