Re: [CAD_CAM_EDM_DRO] Rotary to linear translation - an interesting idea.

This is the way my strip is setup .This in turn is covered by a alum. angel.
I've been using it for a year now without any problems.
Scott Acorn

Ian Wright wrote:

> Of more importance might be altering the design marginally to put the
> measuring wheel UNDER the ribbon to reduce the chances of dust affecting the
> readings and, if possible, shielding the strip from oil contamination which
> would cause the dust or metal particles to stick.
>
> Ian
>
> --
> Ian W. Wright
> Sheffield UK
>
> ----- Original Message -----
> From: D.F.S. <dfs@...>
> >
> > The only way to really know would be to build it and try it.
> >
> > I don't know how plausible a system it is either.
> > A good test will answer that question.
> >
> > I think the only definitive answer is an actual test.
> >
>
> ------------------------------------------------------------------------
> Get paid for the stuff you know!
> Get answers for the stuff you don’t. And get $10 to spend on the site!
> http://click.egroups.com/1/2200/2/_/423600/_/955481402/
> ------------------------------------------------------------------------
>
> Welcome to CAD_CAM_EDM_DRO@...,an unmoderated list for the discussion of shop built systems in the above catagories.
> To Unsubscribe, read archives, change to or from digest.
> Go to: http://www.onelist.com/isregistered.cgi
> Log on, and you will go to Member Center, and you can make changes there.
> For the FAQ, go to http://www.ktmarketing.com/faq.html
> bill,
> List Manager