CAD CAM EDM DRO - Yahoo Group Archive

Re: Threading

Posted by Fred Smith
on 2004-02-15 01:12:14 UTC
--- In CAD_CAM_EDM_DRO@yahoogroups.com, "motorworksnf"
<motorworksnf@y...> wrote:
> Hi
> I got my lathe Threading today.
> I wrote a small program to test the encoder and make a 4 pass
thread.
> 1" with 20 tpi. After the last pass a message came up saying that
the
> z axis could not keep up. Ran the program several times and each
time
> at the end the same message came up.
> I increased the accel,max speed etc. and there was no difference.
> Tried slowing the spindle down and the same results.
> If you have any ideas please let me know.
> eddie

What machine/controller, etc. What rpm are you trying to run?

Fred Smith - IMService

http://www.imsrv.com/hobby for specials and discounts.

Discussion Thread

Bill Darby 2000-11-01 07:50:44 UTC [CAD_CAM_EDM_DRO]Threading Alan Marconett KM6VV 2000-11-01 11:21:40 UTC Re: [CAD_CAM_EDM_DRO]Threading JanRwl@A... 2000-11-01 14:46:13 UTC Re: [CAD_CAM_EDM_DRO]Threading Alan Marconett KM6VV 2000-11-02 02:03:51 UTC Re: Threading Bill Darby 2000-11-02 04:54:20 UTC Re: [CAD_CAM_EDM_DRO] Re: Threading motorworksnf 2004-02-14 16:32:10 UTC Threading Fred Smith 2004-02-15 01:12:14 UTC Re: Threading motorworksnf 2004-02-15 04:42:43 UTC Re: Threading Fred Smith 2004-02-15 11:45:07 UTC Re: Threading motorworksnf 2004-02-15 14:14:47 UTC Re: Threading Fred Smith 2004-02-15 21:23:54 UTC Re: Threading motorworksnf 2004-02-16 13:15:45 UTC Re: Threading